• Double check that you have turned scheduled recording on.
• You may be in Quad Mode. Exit Quad Mode before starting scheduled recording. Press
the Quad button on the remote to exit.
Q: Can I record in Auto Sequence Viewing Mode?
A: Yes. Set the system to Scheduled Recording. Then set the viewing mode to Auto Sequence.
Note that the recorder only records what it sees on-screen. This means that you will only record
video from a particular channel when it is displayed on the monitor.
Q: Can I set specific days of the week for the system to record?
A: You can only specify to record at a particular time of day (for example, everyday from 9:00
a.m to 5:00 p.m).
Note: System utilizes a 24-hour clock (i.e 15:00 is 3:00pm).
Use the Schedule Record menu to set start and stop times for Schedule Recording. During this
time block, the system records continuously from one specific camera, or from any cameras in
Auto Sequence Viewing Mode.
Q: I noticed that the system is recording back to back video files while in Motion Recording
setting. Why is that?
A: Reasons for this could be as follows:
1. The camera(s) may be located in a busy area with lots of movement (i.e. side walk).
Either A) Change recording setting to Schedule Recording and select a camera which
covers the most critical area B) Try to point the camera a bit more downwards so it does
not pick up as much of the (foot) traffic.
2. When having more than 1 camera set up, you may have 2 or more cameras pointed at
the exact same area (from different vantage points). This causes them to pick up motion
at the same time and create back to back recordings. Change the viewing area of one or
more cameras so they don’t overlap.
Viewing A/V Output
Q: I have connected the A/V output cable to my TV/monitor. Why does the image not
appear on the TV/monitor?
A: You need to press the AV button on the remote to transfer the image from the LW2702 to the
TV/monitor.
NOTE: It takes approximately 5 seconds for the image to appear on the TV/Monitor.
Q: When using A/V output, can I watch the video on the TV/monitor, and on the LW2702
at the same time?
A: When using A/V output, the LCD screen blacks out. The image only appears on the television
screen.
67
To Next Page
Loading...
Need help?
General
