Basic System Setup4
Step 2 of 2: Add the cameras to your NVR:
1. Right-click and select Camera Registration.
2. Click Device Search. The system searches the network for compatible cameras.
NOTE
It may take a few minutes after you power up IP cameras for them to appear in your search.
3. Check the camera(s) you would like to add.
4. Click Add. The Status indicator turns green to show the camera is successfully connected.
NOTE
You can also add a camera to a specific channel by hovering the mouse over an empty channel in split-screen
view and clicking
. Double-click the camera you would like to add, then right-click to exit.
#LX400117; r. 6.0/57895/57895; en-US 11
To Next Page
Loading...
