Safety
Safety 1-
21
non-concentrated and lose capability of judgment and control so as to cause serious accident.
Ensure good ventilation before you start the engine in a closed area.
open doors and Windows should be carefully kept open. Exhaust gas may enter or be blown in by the
wind, posing a hazard.
Keep Good Field of View
Stop operation if there is not a good field of view. Rain, snow, fog and dust may blur the field of view. It
is not recommended to work until the weather becomes better and the dust settles. In nighttime, lighting should
be provided on the equipment and at work site to create a good field of view.
Fire protection of diesel, oil and hydraulic oils
When filling fuel oil, engine oil, antifreeze liquid and
hydraulic oil, the site should be well ventilated. The
machine should be shut down and lamps, control lever and
startswitchshouldbeturnedoff.Alwayskeepthe
equipment away from flame and heat source. Must turn off
or remove auxiliary heating elements and other equipments
that may produce spark.
Static electricity may produce spark at the nozzle of
filler Always keep the nozzle to contact with the inlet port to
ensure grounding.
Do not start the equipment until the caps on tanks for
fuel oil and other liquid are replaced and tightened.
Figure1-41
Auxiliary Start or Battery Charging
Turn off all electrical equipments including battery
charger and auxiliary start equipment before you connect the
cable to the battery.
If you use another equipment or vehicle for auxiliary
start, avoid the contact between the two equipments.
Figure1-42
The cable for auxiliaries or charger should be connected with the positive terminal. The negative terminal
of the auxiliary battery should be connected with the metal frame of the auxiliary charger. Please refer to the
operation procedures and instructions in this manual. The cable for auxiliaries or charger should be connected
with the positive terminal. The negative terminal of the auxiliary battery should be connected with the metal
To Next Page
Loading...