Operation
40 MultiPress S Operating manual 3.0 Rev: 3.6.2009
6.3 Setting the basic functions
To edit the basic functions, proceed as follows:
› In the main menu, select the entry Setup.
› Press the ENT key.
"Setup" appears in the menu box.
› Select the desired entry in the selection list and press the ENT key.
The selection options are explained in Table 2 on page 40.
Tab. 2: Setup menu
Fig. 15: Display in the
Setup menu
S e t u p LPKF s e t
L a n g u a g e
ESC p r e h e a t ? ENT
2 0 ° C 2 0 ° C
Menu item Selection options Function/Explanation
Language
German (Factory setting) Display in German
English Display in English
preheat?
Off (Factory setting) Preheating stage can only be started
manually.
On The preheating stage is started
automatically with the profile selected last,
after switching on the MultiPress S on the
main switch. Activate this option only if
you always use the same profile.
firmware
Software version is displayed in the
selection box
hours
The number of previous operating hours
is displayed in the selection box
(Table page 1 of 2)
To Next Page
Loading...