LS tractor MT563 - Clutch Button (PSS); CAL;SEL Switch (PSS)

3 -41
(3) Clutch button (PSS)
 It is used to engage/disengage the main clutch
before shifting the main gear shift lever instead
of the clutch pedal.
 If pressing/releasing the clutch button, the
engine power will be disengaged/engaged.
 When pressing this button, the neutral indicator
on the instrument panel will blink.
(4) CAL/SEL switch (PSS)
 This switch is used to calibrate automatically of
the power shuttle system oil pressure.
 EHL : Electric hydraulic lift models
MHL : Mechanical hydraulic lift models
 Comply with the following instruction;
1. Start engine and release the parking brake on a
level surface.
2. Place the power shuttle lever, main gear shift
lever and range gear shift lever.
3. Put throttle lever to the “Low” speed.
4. Press this switch over 3-seconds with
depressing clutch pedal fully to start the
automatic oil pressure calibration mode.
5. Place the power shuttle lever to the forward or
reverse position. The automatic oil pressure
calibration will start.
6. After the process is finished, place the power
shuttle lever in neutral position.
 To stop the calibration mode during the process,
place the power shuttle lever in neutral position.
CAL/SEL switch
EHL
CAL/SEL switch
MHL
▶Be careful that this switch is not pressed by unintended operation.
Caution
Clutch button
Main gear shift lever
▶Be careful that this clutch button is NOT pressed by unintended operation.
▶Use this button only for shifting the main gear shift lever while driving. If using this
button when starting, the engagement shock can be increased considerably.
Caution