3 -10
Key switch
OFF
ON
Start
Throttle pedal
(3) Throttle pedal
This pedal is used when driving on the road.
When using the throttle pedal, the throttle lever
must be placed in “Low speed” position.
When pressing brake pedals with pressing the
throttle pedal first, the engine speed will be
changed to the low idle speed.
When pressing the throttle pedal with pressing
brake pedals first, the engine speed will be
controlled by the throttle pedal according to its
stroke.
There is a sensitive electric sensor on the
throttle pedal. Do not remove or modify the
throttle pedal arbitrarily.
Brake pedals
(2) Key switch
OFF - power off (engine stop)
ON - power on & automatic glow
Start - engine start
As soon as the engine starts, turn the ignition
key to ON position immediately. If not, it may
cause damage to the starter motor.
▶ Because a safety switch for start-up has to be engaged, put PTO switch to “OFF”
position, depress the clutch pedal fully, and place the F/R shuttle lever in neutral
position, and then turn the key switch to “Start” position. See chapter 4-2-(1),
“Engine Start” in this manual.
▶ If the tractor is not in use, the ignition key should be removed.
Caution
To Next Page
Loading...
