4 -23
Implements with a high power requirement
should be operated with the 1000 rev/min PTO
(21-spline shaft). (optional)
When using the PTO output shaft to operate
implements, it is recommended if possible that
the implement is fitted with a slip clutch to avoid
damage to the PTO output shaft and other
tractor components.
▶ Do not engage the PTO clutch at high engine speed. Sudden engagement can
cause damage to the implements, PTO clutch and drive line. Engage the PTO at low
idle rpm, and then raise the engine speed up.
Caution
Example of slip clutch
Example of PTO drive shaft
To Next Page
Loading...
