This describes on the software tool for the Pnet I/F module. For programming and application, refer to the
(1) You can download the above software from our web site. In case Internet is available, visit the
nearest distributor and get the installation CD.
Web site address: http://www.lselectric.co.kr/
(2) You can program the XG5000 through the RS-232C port and USB of the CPU module. For the
cable, refer to wiring diagram of the CPU module.
(3) You can configure the network system by SyCon through the “Config” port of the XGL-PMEA.
Only 9-pin serial port is available and simultaneous connection with XG5000 is not available.
(4) You can set the parameter by N Configurator for XGL-PMEB/C through the USB port of the CPU
module and connection with XG5000 is available.
(5) In case you use the product other than available version, some function may not work properly. If
possible, use the recommended version and check the compatibility.
To Next Page
Loading...
Need help?
General
