To Next Page
B
bakerkimJul 29, 2025
What to do if I see a bus error on my LS Control Unit?
- MMorgan HendersonJul 29, 2025
In case of a bus error, you should check the cable for shorts and test the module using a different speed.
What to do if I see a bus error on my LS Control Unit?
In case of a bus error, you should check the cable for shorts and test the module using a different speed.
General| Brand | LS |
|---|---|
| Model | XGT Series |
| Category | Control Unit |
| Language | English |
Describes the Pnet I/F Module for Programmable Logic Control systems.
Safety instructions to be read thoroughly before using the product for safe operation.
Safety precautions specifically for the design phase of PLC systems.
Safety precautions for the physical installation of PLC modules and components.
Safety guidelines to follow during the wiring process of PLC systems.
Safety precautions for testing, operating, and maintaining the PLC equipment.
Safety precautions to be taken before installing the Pnet I/F module and related components.
Outlines the sequence of steps from system installation to product operation.
Precautions for system configuration during test operations.
Explains the network system configuration for XGT Pnet with Smart I/O.
Details how to use the XG5000 program for setting High-speed link parameters.
Explains how to register the communication module within the XG5000 software.
Guides on uploading High-speed link parameters and configuration using SyCon.
Details the screens and parameters for setting up P2P communication in XG5000.
Introduces the initial screens for network and edit views in SyCon.
Explains the methods for selecting a master device in SyCon.
Explains how to select and insert slave modules into the network configuration.
Introduces the online functions in SyCon for downloading and diagnosing network status.
Guides on composing the network by selecting and dragging master modules like XGL-PMEC.
Explains how to compose slave modules by selecting them from the device list and dropping them.
Explains the process of downloading and uploading network configurations to the master module.
Details how to set High-speed link parameters using the XG5000 software.
Details how to set P2P parameters using the XG5000 software.
