EasyManuals Logo

LS XGT Series User Manual

LS XGT Series
200 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Safety Instruction
3
Safety Instructions for design process
Safety Instructions on installation process
I/O signal or communication line shall be wired at least 100mm away from a high-voltage
cable or power line. Fail to follow this instruction may cause malfunctions from noise
Caution
1. Use PLC only in the environment specified in PLC manual or general standard of data
sheet. If not, electric shock, fire, abnormal operation of the product may be caused.
2. Before install or remove the module, be sure PLC power is off. If not, electric shock or
damage on the product may be caused.
3. Be sure that every module is securely attached after adding a module or an extension
connector. If the product is installed loosely or incorrectly, abnormal operation, error or
dropping may be caused. In addition, contact failures under poor cable installation will be
causing malfunctions as well.
4. Be sure that screws get tighten securely under vibrating environments. Fail to do so will
put the product under direct vibrations which will cause electric shock, fire and abnormal
operation.
5. Do not come in contact with conducting parts in each module, which may cause electric
shock, malfunctions or abnormal operation.
Caution

Table of Contents

Other manuals for LS XGT Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LS XGT Series and is the answer not in the manual?

LS XGT Series Specifications

General IconGeneral
BrandLS
ModelXGT Series
CategoryControl Unit
LanguageEnglish

Related product manuals