Lucent Technologies MERLIN LEGEND Release 6.1 Maintenance And Troubleshooting

MERLIN LEGEND Communications System Release 6.1
Maintenance and Troubleshooting
555-661-140
Issue 1
August 1998
Page 4-84
800 NI-BRI Module Problems
Table 4–7. Continued
Result
Code Description Corrective Action
&29
continued
Provisioning on the facility does not
always allow outgoing and/or incoming
calls. Error identified at Outgoing Voice Call
Test, Step 4 and/or Incoming Voice Call Test,
Step 2.
This condition may or may not be detected by
any single manual test. Therefore, a
sequence of calls may be necessary to
determine the condition for the failure.
&2'
CO provisioning
error for data calls
on that facility
The facility is correctly programmed and
established on Layers 1, 2, and 3. However, a
problem associated with the provisioning at
the CO for data calls was detected.
If the facility is intended to provide data calls,
perform the following tests with either digital
data terminals or analog data terminals and
modem pools. Record the results before
contacting the LEC:
Outgoing Data Call Test (see page 4-96
)
Incoming Data Call Test (see page 4-97
)
If data terminals are not available, contact the
LEC and advise them that the provisioning for
data on the facility requires checking. If more
information is required, contact the NSAC
and provide them with the result code, the
slot number, the port number, and the site
information (remote access number, etc.).
Continued on next page

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English