Lucent Technologies MERLIN LEGEND Release 6.1 Maintenance And Troubleshooting

MERLIN LEGEND Communications System Release 6.1
Maintenance and Troubleshooting
555-661-140
Issue 1
August 1998
Page 2-13
Error Logs
Table 2–2. Error Codes (Continued)
Error
Codes Description Action
& %($5(5
&$3$%,/,7<,1&203$7,%,/,7<
A 64 kbps clear-channel data call was
routed to a facility that does not have
sufficient bandwidth to handle the call.
Verify that the ARS or UDP routing tables
route a data call to a DS1 facility. Check
the DS1 Type administration item for the
specified facility. If the programmed value
is
T1 , the caller must initiate a 56 kbps
call. Check the DS1 Suppression
administration item for the specified
facility. If the programmed value is
AMI-ZCS , the caller must initiate a 56
kbps call.
 $/$507$%/( )8// 
The error logs are full, and no more
errors can be added to them.
Turns on the processor LED.
Correct indicated errors, and then remove
entries from the transient system error log
to free up space. If problem persists,
cold-start the system before continuing
with troubleshooting.
6\V3URJUDP → 6\VWHP → 5HVWDUW
 86(55(48(67('6<6(5$6(
This error is logged after a System
Erase. If the System Erase is
successful, this error is removed
immediately.
If this error remains in the transient log, do
the System Erase again. If problem
persists, troubleshoot the processor.

86(55(46783*5',167$//
:
This is just a record of the event.
No action required.
&
322/(037<
:
The system needed to use a trunk in a
pool but no trunks were physically
present in the pool, that is, all of the
boards were removed from the
system. See first argument number on
the screen for pool index (1–11).
Check that the pool has a trunk assigned
to it. If a trunk is assigned and the
problem persists, replace the boards.
Continued on next page

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English