Lucent Technologies MERLIN LEGEND Release 6.1 Maintenance And Troubleshooting

MERLIN LEGEND Communications System Release 6.1
Maintenance and Troubleshooting
555-661-140
Issue 1
August 1998
Page 2-14
Error Logs
Table 2–2. Error Codes (Continued)
Error
Codes Description Action
&
322/%86<
:
The system needed to use a trunk in a
pool. Trunks are physically present;
however, non are idle and available
for use, therefore they must be in use
or out of service. See first argument
number on the screen for pool index
(1–11).
Check the count and first and last
occurrences. If occurring too frequently,
determine if facilities can be added or
moved to this pool.
&
322/%86<25226
:
The system needed to use a trunk in a
pool. Trunks are physically present,
some may be busy but some are idle.
However, the idle trunks are not in
service. See first argument number on
the screen for pool index (1–11).
Restore if out of service.

See error code 0801
& '6/2662)6,*1$/$/$50
Service on the link has been lost.
Usually no action is required.
Troubleshoot the T1 trunk, channel
service unit (CSU), and the cable
between the CSU and the 100D module.
If problem persists, escalate to your
technical support organization.
& '6%/8($/$50
All unframed ones signal being
received. The link cannot be used for
communication.
Blue alarms are generated by
intermediate equipment, such as a CSU
or DDM 1000/2000. The far end of the
network interface may be out of service.
Troubleshoot the T1 trunk, channel
service unit (CSU), and the cable
between the CSU and the 100D module.
If problem persists, escalate to your
technical support organization.
Continued on next page

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English