MODEL 9DP-1 Operator’s Manual
Ludlum Measurements, Inc. 44 December 2015
Data Logging
The 9DP-1 is capable of logging instrument information to a file on a USB
thumb drive at a pre-defined interval in a CSV (comma separate value)
format.
7.1 Data Description
Below is a list of all of the data that may be recorded in the log file.
Event
“Event” is a numerical counter which increments with each log event. If the
thumb drive is removed from the instrument at any time during data logging,
the event counter will reset to 1 when the thumb drive is reconnected to the
instrument. Event is a numerical value from 1 to 4294967295 and is always
included in the log file.
Type
“Type” is a text value which indicates the type of event that is being
recorded. If data logging is enabled, all events which occur at the preset
interval are defined as Log events. If data logging of the “Integrate” feature is
requested (see Section 6.4.1), these events will be defined as Dose events.
“Type” is always included in the log file.
Location
“Location” is a text value which is user defined. The “Location” is assigned
by the user and will remain as the current location until the “Location” is
cleared by the user.
Note: “Location” is not available with the current firmware release.
Status
“Status” is a text value which is instrument defined.
To Next Page
Loading...
Need help?
General
