MODEL 9DP-1 Operator’s Manual
Ludlum Measurements, Inc. 47 December 2015
Integrate Units
“Integrate Units” is a text value representing the units associated with the
Integrate feature. For more information, see Section 6.4.1.6.3.
7.2 Setup
Perform the following steps to set up “Data Logging.”
1. Setup Logged Data
To set up what data may be viewed in the data logging report, refer to
Section 6.4.2.5. Move through each section in the menu and enable all of
the data that should be reported.
2. Setup Sample Period
Once all of the data that is to be reported has been selected, determine
how often the data should be written to the file by setting the sample
period. Refer to Section 6.4.2.4 for more details.
3. Setup Delay On Power Up
Once the sample period has been selected, determine how long to wait
before the first data is recorded. This delay refers to the amount of time
after powering up the instrument with the thumb drive connected,
amount of time to delay after the thumb drive has been inserted into the
instrument, or the amount of time to wait after Data Logging has been
enabled. Refer to Section 6.4.2.3 for more details.
4. Setup Operating Mode
Operating mode will immediately enable or disable Data Logging. When
the instrument is turned off, this value will be saved in internal memory.
The next time power is applied, the instrument will look at the value of
“Power Up Mode” to determine the status of the Data Logging feature.
If the value of “Operating Mode” is “Last,” the instrument will resume
operation based on the stored value of “Operating Mode.” See Section
6.4.2.2 for more details.
5. Setup Power Up Mode
Any time power is applied to the instrument, the instrument will look at
“Power Up Mode” to determine if the data logging will be enabled or
disabled. If the value of “Operating Mode” is “Last,” the instrument will
resume operation based on the previously stored value of “Operating
Mode.” See Section 6.4.2.1 for more details.
To Next Page
Loading...
Need help?
General
