Navigation functions include:
• Airport and airspace database for Europe or USA, an almost unlimited number of AS sections can be
stored
• Turn points in .cup format, an almost unlimited number of files can be stored, up to three active files can be
used at the same time
• A wide range of task options, either imported as a part of .cup files, user created in addition to one declared
task
• Statistics, flight statistics and task statistics
• Display of nearest airports and out landing fields
• Support of AAT (assigned area task)
• Distance measuring equipment in TP and APT mode
• Multi pilot function (storing of 100 pilots names with their individual settings)
Flight recorder functions include:
• Integral pressure transducer based on 1013 mb level, for altitude recording
• Integral Engine Noise Level sensor
• Memory to store typically 100 flight hours (hardly depends on settings)
• Digital and mechanically security device to ensure high level of data security
Interfaces:
• PDA interface powers and sends data to a PDA. Programs supported:
SeeYou Mobile, Winpilot Version 7 or higher, Navigator, LK 8000
• User interface powers and sends NMEA at various baud rates, connection to a transponder possible.
• SD Card interface for data transfer and firmware update
• IGC interface to connect and power Colibri or LX 20. The connector pin out corresponds to the IGC
standard and may be used to power the LX 7007 and to communicate with PC also, by the use of a
standard Colibri Power adaptor. Whilst training, this input can be used to connect to Condor flight
simulator.
Options:
• Integral Flarm, collision avoidance system
• Remote control, for both seats
• Two seater configuration
• Compass
• Secondary LCD colour vario indicators
• Voice Module, to give voice warnings and information.
1.1 Technical data
• Power input 10-16 V DC
• Consumption: 210 mA @ 12V (without audio and options), 260 mA with Flarm option
• 80mm (3") standard Aircraft cut-out for LX 7007 DU
• 57mm (2 1/4") standard Aircraft cut-out for USB D Length 120 mm (incl. connector)
• Three physically separated com. Ports:
-PDA port with 5V power supply delivers NMEA and task data to PDA and allows data transfer
- IGC com port with IGC standard connector, suitable to connect Colibri or LX 20 or PC
- User port for GSM Modem connection
• Drives the following PDA programs: SeeYou Mobile, Navigator, LK 8000, and Winpilot….
• PDA data exchange with ConnectLX, ConnectMe, Navigator
• 16 Channel GPS receiver
• SD card interface
• External speaker
• System bus enables connection to a wide range of options
• Built in fuse to prevent damage in the event of a short on the 485 bus
• Data compatible with LX 20 and Colibri
• IGC approved flight recorder
• Weight: apr. 800g
To Next Page
Loading...
Need help?
General
