Lynx
®
NGT-9000
Pilot’s Guide 1-3
Description
SPECIFICATIONS
Part Number: 9029000-40000 (remote mount)
Weight: 2.75 Lbs Nominal.
Power
Requirements:
+14.0 VDC nominal or +28.0 VDC nominal.
17.0 watts nominal, 24.0 watts maximum
Start Up Time On Ground 20 seconds or less
In air 5 seconds or less.
Built In Test: Fault Monitoring on all stages of operation
from start up to power down.
Interfaces: ARINC 429, RS-422, RS-232, Discrete In-
put/Outputs, RF Suppression Bus, and DCM
serial interface .
Functionality: Mode S Transponder (1030/1090)
Global Positioning System (GPS)
ADS-B Receive: (1090ES/UAT)
ADS-B Transmit: (1090ES)
TIS-B (1090ES)
FIS-B (UAT)
Mode S Transponder Diversity (optional)
(1090ES)
Traffic Awareness System (TAS) (optional)
•
•
•
•
•
•
•
•
Service Life: Unlimited.
Scheduled
Maintenance:
The Lynx NGT-9000 is a transponder device
and must be tested and inspected every 24
months subject to the requirements of FAA
documents 91.413.
Repairs: Repairs performed at the FAA certificated
Repair Station co-located at the OEM (equip-
ment) facility.
Compliance: The Lynx NGT-9000 has been shown to meet
the requirements in TSO-C166b and meets
the requirements of 14 CFR 91.225b installed
in accordance with these installation instruc-
tions.
To Next Page
Loading...
