Lynx
®
NGT-9000
Pilot’s Guide5-12
Troubleshooting
Table 5-3: Troubleshooting for the Remote Mount Lynx NGT-9000
SyMPtoM cauSe/corrective actionS
CP-2500 displays “NO
TIS-B COVERAGE”.
No targets are shown
on the compatible traffic
display.
If installed, ADS-B Fail
lamp is OFF.
•
•
•
The aircraft is not in an ADS-B
(1090ES) coverage area, or the
targets are not transmitting ADS-B
data, or the ground station is not
transmitting TIS-B data.
The symptoms are normal if the
target or ground station are not
transmitting TIS-B.
This message is removed when
the aircraft is within coverage
area range of an TIS-B ground
station.
The target or ground station
needs to be within line-of-site
range.
At next power cycle if symptoms
persist contact L-3 Field Service
before removal of the unit or
other equipment.
1.
2.
3.
4.
Traffic display is working
correctly, but aircraft are not
showing up on the display.
Lack of data as described below:
The ADS-B In requires other
aircraft to be equipped with ADS-
B Out.
The TIS-B and ADS-R services
are supported when in range of
ground stations providing the
service.
If receiving the TIS-B service,
Mode C and Mode S transponder
equipped aircraft that do not
provide altitude information are
not seen on the traffic display.
If receiving the TIS-B service,
but aircraft not equipped with a
transponder, or equipped with a
Mode A transponder are not part
of the TIS-B data and will not be
seen on the traffic display.
•
•
•
•
To Next Page
Loading...
Need help?
General
