214328 66 Revision A
Figure 5.29: Single-Reel Header
Figure 5.30: Double-Reel Header
5. Measure clearance at ends of each reel at locations (A).
NOTE:
The reel is factory-set to provide more clearance at
center of reel than at ends to compensate for
reel flexing.
Figure 5.31: Reel Clearance
6. Check clearance (X) between (B) and (C). Depending
on reel fore-aft position, minimum clearance can result
at guard tine, hold-down, or cutterbar.
7. Adjust reel if necessary. Refer to 5.9.3 Adjusting Reel
Clearance, page 67.
PERFORMING PREDELIVERY CHECKS
To Next Page
Loading...
