Section
Summary of Change
Internal Use Only
3.2.5 Installing Transport Swing
Cylinder, page 22
• Step 6, page 23
Revised the step to read “rod end” (previously was
“clevis end ”). Added part numbers for clarity:
• MD # 281101
• MD #18609
Product Support
Tech Pubs
3.2.6 Installing Transport Alignment
Control, page 23
Removed a step regarding the cam assembly shipping
support that was only applicable to the factory-installed
transport option.
Tech Pubs
3.2.6 Installing Transport Alignment
Control, page 23
• Step 5, page 24
• Step 6, page 25
Revised steps and NOTE to clarify that the rod end of the
cylinder is being installed.
Product Support
3.2.6 Installing Transport Alignment
Control, page 23
• Step 9, page 26
Corrected part number to MD #247625. Was
MD #247598.
Tech Pubs
3.3.1 Installing Hydraulic Lines and
Hoses, page 27
Revised NOTE:
• Refer to the rotary disc pull-type operator’s manual
or technical manual for hydraulic fitting installation
details.
Tech Pubs
3.3.1 Installing Hydraulic Lines and
Hoses, page 27
• Step 1, page 27
Added picture to clarify step. Tech Pubs
3.3.1 Installing Hydraulic Lines and
Hoses, page 27
• Step 4, page 27
Added IMPORTANT.
Tech Pubs
3.3.1 Installing Hydraulic Lines and
Hoses, page 27
• Step 5, page 27
Added part number of fitting for clarity.
Tech Pubs
3.3.1 Installing Hydraulic Lines and
Hoses, page 27
• Step 10, page 28
• Step 11, page 28
• Added part number MD #247781 for clarity.
• Revised steps to correctly identify ports C and D.
Tech Pubs
3.3.1 Installing Hydraulic Lines and
Hoses, page 27
• Step 12, page 28
Added part number MD #30753 for clarity.
Tech Pubs
3.3.1 Installing Hydraulic Lines and
Hoses, page 27
• Step 13, page 29
• Step 14, page 29
Added part number MD #246366 for clarity.
Tech Pubs
3.3.1 Installing Hydraulic Lines and
Hoses, page 27
Added part number MD #30753 for clarity. Tech Pubs
214633 v Revision C
To Next Page
Loading...
