To Next Page

To Previous Page

Rev. Date 040819

Caution & Safety

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH.

Read and understand this manual before installing or operating a fan unit. Installation,

adjustment, repair, or maintenance must be performed by qualied personnel.

The user is responsible for compliance with all international and National Electrical Code

requirements with respect to the grounding of all equipment.

Many of the parts of this unit operate at live voltage. DO NOT TOUCH.

Install all covers before applying power or starting and stopping the unit.

WARNING - TO REDUCE THE RISK OF ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE

THE FOLLOWING:

a) Use this unit only in the manner intended by the manufacturer. If you have questions, contact

the manufacturer.

b) Before servicing or cleaning the unit, switch power off at the service panel and lock the service

disconnecting means to prevent power from being switched on accidentally. When the service

disconnecting means cannot be locked, securely fasten a prominent warning device, such as a

tag, to the service panel.

WARNING: If unusual oscillating movement is observed, immediately stop using the ceiling fan

and contact the manufacturer, its service agent or suitably qualied persons.

WARNING: Make sure to power the fan off and lock it out using the IEC/CE approved disconnect

when doing any cleaning and or maintenance to the equipment.

PRIOR TO THE INSTALLATION, ENSURE:

• That the mounting of the suspension system shall be performed by the manufacturer, its

service agent or suitably qualied persons;

• That the fan is to be installed so that the blades are more than 10ft [3.05m] above the oor;

• The model or type reference of a luminaire that may be installed in a fan constructed for

this purpose.

DAMAGED EQUIPMENT

Do not operate or install any fans or fan accessories that appear to be damaged. Failure to follow

this instruction can result in death, serious injury, or equipment damage.

SERVICE:

If the fan does not operate properly using the procedures in this manual, BE CERTAIN TO

REMOVE ALL POWER TO THE UNIT and contact our technical department for further assistance.

Keep clear of moving parts at all times. All electrical troubleshooting and repair must be done by

a qualied technician and meet all applicable codes.

Ensure that the replacement of parts of the safety suspension system device shall be performed

by the manufacturer, its service agent or suitably qualied persons.

MacroAir Technologies EnergyLogic AVD3 User Manual

Questions and Answers: