Manitowoc Grove GRT9165 Service Manual

6-20
Published 10-01-2020 Control # 699-00
SWING SYSTEM GRT9165 SERVICE MANUAL
Removing the Slew Sensor
1. Disconnect transducer connectors (2) from slew sensor
(1).
2. Remove capscrews (3), washers (4), left pinion
protection shield (5), and slew sensor (1).
3. Remove capscrews (6), washers (7), and plate (8) as
necessary.
Installing the Slew Sensor
1. Install plate (8) on superstructure with washers (7) and
capscrews (6).
2. Install slew sensor assembly (1) and left pinion
protection shield (5) with washers (4) and capscrews (3).
3. Connect transducer connectors to slew sensor
assembly.
4. If install new transducers, you must re-calibrate the
sensors. For more information, see Calibrating ODM
Sensors, page 3-20.

Manitowoc Grove GRT9165 Specifications

General

Brand	Manitowoc
Model	Grove GRT9165
Category	Construction Equipment
Language	English