Mannesmann ecodrive03 - Diagnostic Messages for Basic Initialization and after Fatal System Errors; Diagnostic Message Display: -0; Diagnostic Message Display: -1; Diagnostic Message Display: -2

4-40 Description of Diagnostic Letters B..., C..., D... and A... ECODRIVE03 SMT-02VRS
DOK-ECODR3-SMT-02VRS**-WA01-EN-P
4.3 Diagnostic messages for basic initialization and after fatal
System errors
Diagnostic Message Display: -0
The writable data storage of the drive controller is tested for its functional
capability.
If an error is detected, E2 is displayed.
Diagnostic Message Display: -1
The hardware of the amplifier is beig initialized.
Diagnostic Message Display: -2
Cause:
The control supply voltage of the encoder is missing.
Remedy:
Exchange the hardware.
Diagnostic Message Display: -3
Initializing the parameters from the non volatile memory and calculating
the respective data depending from the parameter contents.
Diagnostic Message Display: -4
Initializing and checking the command communication.
Diagnostic Message Display: -5
Initializing the system control.
Diagnostic Message Display: -6
Starting the system.
Diagnostic Message Display: (2 dots)
Causes:
1. Programming mode
2. The prozessor does not run at all because of hardware fault.
Remedies:
For 1. Reload firmware program by Indramat customer service.
For 2. Exchange the hardware.