Mannesmann ecodrive03 - Replacing the Firmware Module; Replacing the Programming Module (Complete Module)

6-8 Replacing Firmware ECODRIVE03 SMT-02VRS
DOK-ECODR3-SMT-02VRS**-WA01-EN-P
6.2 Replacing the Firmware Module
•
Switch unit off
•
Pull programming module out
•
Open the lock on the back of the programming module
•
Open the programming module
•
Insert old parameter module into new firmware module
•
Close lock (lock must be pushed outward)
•
Insert programming module
•
Switch unit on
6.3 Replacing the Programming Module (complete module)
•
Secure parameters (DriveTop)
•
Switch unit off
•
Pull programming module out
•
Insert new programming module
•
Switch unit on
•
Load parameters