Mannesmann ecodrive03 - 2.10 Protection During Handling and Installation; 2.11 Battery Safety

ECODRIVE03 SMT-02VRS Safety Instructions for Electric Servo Drives and Controls 2-9
DOK-ECODR3-SMT-02VRS**-WA01-EN-P
2.10 Protection during handling and installation
Under certain conditions unappropriate handling and installation of parts
and components may cause injuries.
CAUTION
Risk of injury through incorrect handling !
Bodily harm caused by crushing, shearing,
cutting and mechanical shock !
⇒
Observe general instructions and safety regulations
during handling installation.
⇒
Use only appropriate lifting or moving equipment.
⇒
Take precautions to avoid pinching and crushing.
⇒
Use only appropriate tools. If specified by the product
documentation, special tools must be used.
⇒
Use lifting devices and tools correctly and safely.
⇒
Wear appropriate protective clothing, e.g. safety
glasses, safety shoes and safety gloves.
⇒
Never stay under suspended loads.
⇒
Clean up liquids from the floor immediately to
prevent personnel from slipping.
2.11 Battery safety
Batteries contain reactive chemicals in a solid housing. Inappropriate
handling may result in injuries or equipment damage.
CAUTION
Risk of injury through incorrect handling !
⇒
Do not attempt to reactivate discharged batteries by
heating or other methods (danger of explosion and
corrosion).
⇒
Never charge batteries (danger from leakage and
explosion).
⇒
Never throw batteries into a fire.
⇒
Do not dismantle batteries.
⇒
Handle with care. Incorrect extraction or installation
of a battery can damage equipment.
Note: Environmental protection and disposal! The batteries
contained in the product should be considered as hazardous
material for land, air and sea transport in the sense of the legal
requirements (danger of explosion). Dispose batteries
separately from other refuse. Observe the legal requirements
given in the country of installation.