2-10 Safety Instructions for Electric Servo Drives and Controls ECODRIVE03 SMT-02VRS
DOK-ECODR3-SMT-02VRS**-WA01-EN-P
2.12 Protection against pressurized Systems
Certain Motors (ADS, ADM, 1MB etc.) and drives, corresponding to the
information in the Project Planning manual, must be provided with and
remain under a forced load such as compressed air, hydraulic oil, cooling
fluid or coolant. In these cases, improper handling of the supply of the
pressurized systems or connections of the fluid or air under pressure can
lead to injuries or accidents.
CAUTION
Danger of injury when pressurized systems are
handled by untrained personnel!
⇒
Do not attempt to disassemble, to open or to cut a
pressurized system.
⇒
Observe the operation restrictions of the respective
manufacturer.
⇒
Before the disassembly of pressurized systems,
lower pressure and drain off the fluid or gas.
⇒
Use suitable protective clothing (for example
protective eyewear, safety shoes and gloves)
⇒
Remove any fluid that has leaked out onto the floor
immediately.
Note: Environmental protection and disposal! The fluids used in the
operation of the pressurized system equipment is not
environmentally compatible. Fluid that is damaging to the
environment must be disposed of separate from normal waste.
Observe the national specifications of the country of
installation.
To Next Page
Loading...
Need help?
General