Index ECODRIVE03 SMT-02VRS
DOK-ECODR3-SMT-02VRS**-WA01-EN-P
Default parameters not available 4-21
Diagnostic Message Display
(2 dots) 4-40
Diagnostic Message Display
-0 4-40
-1 4-40
-2 4-40
-3 4-40
-4 4-40
-5 4-40
-6 4-40
E1 4-41
E2 4-41
E3 4-41
E4 4-41
E5 4-41
Distance home switch - reference mark erroneous 4-19
Double MDT failure shutdown 3-16
Double MST failure shutdown 3-15
Drive active at command start 4-2
Drive active, switching not allowed 4-18
Drive controlled homing procedure command 4-19
Drive controlled interpolation, encoder 1 4-34
Drive controlled interpolation, encoder 2 4-34
Drive controlled interpolation, lagless, encoder 1 4-35
Drive controlled interpolation, lagless, encoder 2 4-35
Drive deceleration to standstill 4-39
Drive does not control in secondary operation mode 1 4-2
Drive does not move 4-24
Drive HALT 4-32
Drive in control at start of command 4-24
Drive in TORQUE control 4-33
Drive in VELOCITY control 4-33
Drive must be in operation mode (phase 4) 4-2
Drive not ready for commutation command 4-23
Drive overtemp. prewarning 3-28
E
Emergency-Stop 3-17, 3-19, 3-37
Encoder 1 failure
quadrant error 3-7
signal amplitude wrong 3-21
Encoder 2 failure
quadrant error 3-10
signal amplitude wrong 3-9
Encoder combination not possible 4-16
Erroneous internal hardware synchronization 3-13
Error during bedding in the brake 4-4
Error during initialisation of the parking axis 3-5
Error during phase progression 3-16
Error during phase regression 3-17
Error during release of the motor holding brake 3-13
Error during search for zero pulse 4-23
Error in feedback processor, SDAI does not show 1 4-2
Error writing to feedback EEPROM 4-2
Excessive deviation 3-7
Excessive position command difference 3-9
Excessive position feedback difference 3-8
External short at status outputs 3-12
F
Feedback 1 initializing error 4-15
Feedback 1 required (P-0-0074) 4-17
Feedback 2 data reading error 4-14
Feedback 2 initializing error 4-15
Feedback 2 required (->S-0-0022) 4-11
Feedback1 data reading error 4-14
Feedrate-override S-0-0108 = 0 3-30
To Next Page
Loading...