ECODRIVE03 SMT-02VRS Index 7-5
DOK-ECODR3-SMT-02VRS**-WA01-EN-P
Selected process block is not programmed. 3-31
Shaft does not turn as expected 4-3
Slave not scanned or address 0 3-35
Spindle positioning requires drive enable 4-22
Start requires drive enable 4-28
Stepper position mode 4-37
Stepper position mode, lagless 4-37
Switching to parameter mode 4-18
Switching to uninitialized operation mode 3-2
T
T2 too small 4-9
T4 > TScyc (S-0-0002) - T4min (S-0-0005) 4-9
Target position out of num. range 3-33
Target position out of travel range 3-29
Time slot parameter > Sercos cycle time 4-7
TNcyc (S-0-0001) or TScyc (S-0-0002) error 4-8
Torque limit = 0 3-31
Torque/force data scaling error 4-14
Torque/Force too small to move 4-24
Travel range exceeded 4-30
Travel range invalid, P-0-0166 & P-0-0167 4-30
U
UL 4-43
UL The motor type has changed. 3-2
Undervoltage in power section 3-6, 3-26, 3-35
Unknown operation mode 4-39
V
Velocity command value > limit S-0-0091 3-33
Velocity data scaling error 4-13
Velocity limit S-0-0091 exceeded 3-24
Velocity loop error 3-23
W
Warning Motor temp. surveillance defective 3-25
Wrong function of encoder 2 4-17
Z
ZKL1-Error at command start 4-26
To Next Page
Loading...