Insert the M14 Bolt through the Mark 7® knuckle and through the ram. We recommend moving
the shell plate platform to the mid/upper position so the index ring isn’t engaged. Make sure
both washers on the M14 bolt as shown in the figure below. Partially tighten with a pair of 7/8”
(22 mm) wrenches.
Figure 15: Inserting M14 Bolt through 650 Ram (Shown Partially Tightened)
Rotate the link arms back down and thread the ½ -13” X 1.25” hex head as shown below
Figure 16: 1/2“ Hex Head Screws Partially Tightened
To Next Page
Loading...
