Installing Optical Decapping Sensor
TM
WARNING – Use of the Mark 7® Decapping Sensor™ is at your risk and only for expert
reloaders. This is a product that is designed to improve the safety of the reloading
operation. NEVER RELY ON THE DECAPPING SENSOR. You must monitor its use –
ALWAYS. Always be close to your machine and available to stop the machine if it needs
to be stopped.
The Mark 7® Decapping Sensor™ Package Includes:
• Mark 7® Decapping Sensor™
• 8-32 X 3/8" socket cap screw and washer (2X)
• 3/8” ID PVC Clear tubing
• Cable Ties
Decapping Sensor™ Installation Instructions
Remove the spent primer bin and bracket on the 650 as shown below
Figure 30: Removing 650 Primer Bracket
To Next Page
Loading...
