proper cleaning.
Figure 32: Blowing Out Decapping Sensor with Compressed Air.
WARNING – Cleaning intervals of the Mark 7® Decapping Sensor™ will vary dramatically
based upon many factors. WE SUGGEST CLEANING THE MARK 7® DECAPPING
SENSOR™ AS OFTEN AS PRACTICAL – IT IS UP-TO YOU TO ENSURE THE SENSOR IS
CLEAN.
If you don’t have mounting holes for the decapping sensor on the bottom of you 650 platform
you will need to upgrade to the new style design Dillon Part # 22060. You will also need the
new style primer punch for both small and large primer Dillon Part # 21380 & # 21381.
To Next Page
Loading...
