Page 96 / 100 Technical Notice V1.0 / 01.09
Appendix
14.2 Disposal of the product
14.2.1 General remarks
In order to protect both people and the environment, any device and its accessories must be disposed
of according to regulations. The legislation and local regulations applicable for the elimination of waste
must also necessarily be respected.
A device may only be dismantled by a qualified technician.
Parts and sub-assemblies removed by the technician cannot be reused, except when their envisaged
use has been approved in writing by the manufacturer. Any future application of such parts must be pre-
cisely detailed in the request.
14.2.2 Preparation
A. Completely drain the hydraulic circuit into an clearly identified empty container.
B. As regards the refrigeration gases, you must use a company authorised for such activities.
C. Extract the gas, store it in resistant pressure vessel bearing the inscription "RECYCLING" and request
the name of a refrigerant fluid recycler.
D. In Switzerland, if the volume of gas is over 3kg, the operation must be declared to the cantonal authori-
ties.
E. When the device is empty of gas, recover the compressor oil in an appropriately identified waterproof
container.
F. The other components of the unit might also be recyclable:
• copper or stainless steel from the exchanger,
• sheet metal,
• copper electrical cables.
To Next Page
Loading...
