Matrix SETU VFXTH System Manual

Matrix SETU VFXTH System Manual 112
Handling of Outgoing Calls
When a SIP Trunk is determined as the destination port, numbers dialed from this port constitute outgoing calls.
• Click Handling of Outgoing calls.
• If you do not want to route outgoing calls through this SIP Trunk, select the Block calls through this SIP
Trunk check box.
• To allow the users to make outgoing calls irrespective of whether the SIP Trunk has been successfully
registered with the proxy or not, select the Route Calls through this port without Registration check
box.
By default, the system does not allow outgoing calls to be made if the status of the SIP Trunk is 'not
registered'.
• By default, the CLI of the SIP Trunk is sent to the called party when outgoing calls are made using the SIP
Trunk. If you do not want to send CLI, enable the CLIR check box. Default: Disabled.
• Select an option you want to send as SIP ID in "FROM" header of INVITE message. You may select:
• SIP ID configured
• Caller ID received on Source Port
• Caller ID after applying Reverse DDI logic
Default: SIP ID configured
• SETU VFXTH also offers flexible options for sending Identity header in INVITE message during an
outgoing call. Select the desired option according to the Identity header supported by your service
provider. You may select:
• None
• P-Preferred Identity
• P-Asserted Identity
Default: None.

Matrix SETU VFXTH Specifications

General

Brand	Matrix
Model	SETU VFXTH
Category	Gateway
Language	English