243 Matrix SETU VFXTH System Manual
• Select the Privacy Algorithm as DES or AES-128. Default: DES.
• Enter the Privacy Password of your choice.The Privacy Password must be a minimum of 8
characters and may have upto 24 characters. Default: Blank.
Notification Settings
• Click Notification Settings to expand.
If SNMP version is set as SNMPv1, configure the following parameters.
• If you want SETU VFXTH to generate Trap message for an error, select the Enable Trap? check box.
Default: Disabled.
• You must configure the Notification Destination, if you have enabled Trap. SETU VFXTH will
send the notification (error message) to the destination configured.
The Notification Destination can be an IP Address or a Domain Name and the Port of the Manager
or of any other device where you want to receive the trap messages. IP Address/Domain Name can
be a maximum of 64 characters. Valid range of the port is 0-65535. Default port is 162.
• Click Submit button to save the settings.
If SNMP version is set as SNMPv2c or SNMPv3, configure the following parameters.
• Select Notification Enable check box, if you want SETU VFXTH to generate Trap or Inform message
for an error.
• Select the Notification Type. You may select Trap or Inform.
If you want the system to send notification message without acknowledgement, select Trap.
If you want the system to send notification message with acknowledgement, select Inform.
• If you select Inform as the Notification Type, you must configure Retry Attempts and Retry Interval.
If acknowledgement is not received from the Manager for the notification sent, the system will keep
retransmitting the message for the number of attempts you have configured as the Retry Attempts.
Default: 3.
The system will retransmit the messages at regular time intervals you have configured as Retry
Interval. Default: 10 seconds.
• Configure the Notification Destination. SETU VFXTH will send the notification (error message) to the
destination configured.
To Next Page
Loading...
Need help?
General
