Matrix SETU VFXTH - Page 262

257 Matrix SETU VFXTH System Manual
• STUN Server Address
• STUN Server Port
• System Parameters - Server Ports
• HTTP Web Server Port
• HTTPS Web Server Port
• FTP Server Port
• Telnet Server Port
• Firmware Parameters
• Configuration Parameters
• Login Password (Jeeves and Command)
To restore the default settings by dialing the system command,
• Lift the handset of phone connected to the FXS Port.
•Dial #19-Command Password to enter the Programming Mode.
• You will get programming tone.
•Dial 51-Reverse Command Password-#*
• Replace handset of the phone.
• The system will restart.
Restoring Default Settings using the Reset button
Using Reset button, you can restore the following parameters to default values:
• SE Password
• Network Parameters
• Connection Type
• IP Address
• Subnet Mask
• Gateway
• VLAN/CoS
• System Parameters
• FTP Server Access from WAN
• Telnet Server Access from WAN
• Allow Server Access from specific IP Address
• IP Address table for Server Access
• Server Ports
• HTTP Web Server Port
• HTTPS Web Server Port
• FTP Server Port
• Telnet Server Port
To restore the default settings using the Reset button,
• Press the Reset button for more than four seconds.
• Release the Reset button.
If you press the Reset button for less than four seconds, SETU VFXTH will restart.