Matrix SETU VFXTH System Manual 260
• In the ACS Password field, enter the password used by SETU VFXTH for HTTP authentication.
Default: Blank.
• In the UDP Connection Request Port field, enter the port on which the ACS will make a connection
request to SETU VFXTH using UDP connection. The valid Port range is from 1031-65535. Default:
54320.
•In the TCP Connection Request Port field, enter the port on which the ACS will make a connection
request to SETU VFXTH using TCP connection. The valid Port range is from 1031-65535. Default:
7547.
• In the Connection Request Username field, enter the username used by SETU VFXTH to
authenticate the incoming connection request made by ACS. Default: Blank.
• In the Connection Request Password field, enter the password used by SETU VFXTH to
authenticate the incoming connection request made by ACS. Default: Blank.
• Select the Periodic Inform check box, if you want SETU VFXTH to check updates available on ACS
periodically. Default: Disabled.
• In the Periodic Inform Interval field, enter the time in seconds after which SETU VFXTH must attempt
to connect with the ACS to check for updates. Default: 1800.
• Select the STUN Enable check box, if your SETU VFXTH is located behind the NAT Router and SIP
messages need to be forwarded to the public network. Default: Disabled.
STUN specifies the mechanism required for NAT traversal in SIP messages.
STUN server facilitates traversing through most NATs, except symmetric NATs. If your router has
symmetric NAT, do not enable STUN.
•In the STUN Server Address: Port field, enter the STUN Server Address and the Listening Port of the
STUN Server.
The STUN Server Address can be a maximum of 256 characters. All ASCII characters are allowed.
The valid range of the STUN Server Port is from 1025–65535. Default: 3478.
• In the STUN Server Username field, enter the username provided by the STUN server to authenticate
the STUN Request. Default: Blank.
• In the STUN Server Password field, enter the password provided by the STUN Server to authenticate
the STUN Request. Default: Blank.
• Click Submit to save changes.
• You may log out of Jeeves.