Matrix SETU VFXTH System Manual

Matrix SETU VFXTH System Manual 62
• For each calling party number, enter a corresponding destination number in the Destination Number
column. Destination numbers may consist of a maximum of 24 characters. Digits 0 to 9, *, # and (.) dot
are allowed. Default: Blank.
• Click Submit to save your entries. Close the window to return to the FXO Port page.
You can also configure the Calling Number Based Table from Advanced Settings links. For
instructions, see “Destination Number Determination” under Advanced Settings.
• For incoming calls with Calling Party Numbers that do not match with the Calling Party Number Table, you
may select the destination number determination method.
In the If no match found in the Calling Party Number Table, route calls box, you may select the option
to the Fixed Destination Number or after Answering the Call and Collecting the Digits. Default: after
Answering the Call and Collecting the Digits.
Route After Answering the Call and Collecting the Digits
In this method, the system answers the incoming call on the FXO Port and plays dial tone to the caller, allowing the
caller to dial the desired number. The number dialed by the caller is considered as the destination number.
To apply this method, do the following:
• In the Route all incoming calls (with CLI) list, click after Answering the Call and Collecting the Digits.
The related parameters appear under Answering the Call and Collecting the Digits.
• Set the following Answering the Call and Collecting the Digits parameters to the desired values.
• To enable PIN Authentication for incoming calls on this port, select the Prompt caller to enter PIN
check box.
If you enable this check box, you must also configure the PIN Authentication Table. To know more
about this feature and for detail instructions, see “PIN Authentication” under Advanced Settings.

Matrix SETU VFXTH Specifications

General

Brand	Matrix
Model	SETU VFXTH
Category	Gateway
Language	English