Matrix Visionpro System Manual

Matrix VISIONPRO System Manual 96
• To restore default values in an allowed list, dial,
1201-1-Allowed List-#
Where,
Allowed List is from 0 to 7.
• To restore default values in all allowed lists at once, dial,
1201-*-#
• Exit SE mode.
Configuring Denied Number List
• Enter SE mode.
• To configure numbers in the denied list, dial,
1204-1-Denied List-Location Index-Number-#*
Where,
Denied list is from 0 to 7.
Location Index is from 00 to 15.
Number is a complete telephone number or a truncated telephone number or an area code. If the number
is less than 16 digits, you must dial ‘#*’ to terminate the command.
• To configure the same number in a specific location index for all the denied lists, dial,
1204-*-Location Index-Number-#*
• To restore default values in a denied list, dial,
1203-1-Denied List-#
Where,
Denied List is from 0 to 7.
• To restore default values in all the denied lists at once, dial,
1203-*-#
• Exit SE mode.
Example: Program Allowed List and Denied List for following requirement:
• Allow all numbers except ‘ISD’.
Solution: On observing the default lists, we can conclude that,
• This condition can be fulfilled using default denied list 5. Assign this list to the required station. See “Toll
Control” for more information.

Matrix Visionpro Specifications

General

Brand	Matrix
Model	Visionpro
Category	PBX
Language	English