Matrix VISIONPRO System Manual 104
Auto Redial Dial Tone Wait Timer
It specifies the time for which VISIONPRO waits before executing Auto Redial.
To configure,
• Enter SE mode.
•Dial 3031-Seconds
Where,
Default: 003 seconds.
Valid Range: 000 to 255 seconds.
• Exit SE mode.
Auto Redial Ring Back Tone (RBT) Wait Timer
It specifies the time for which VISIONPRO waits to sense RBT from the PSTN after dialing the requested number.
To configure,
• Enter SE mode.
•Dial 3032-Seconds
Where,
Default: 060 seconds.
Valid Range: 000 to 255 seconds.
• Exit SE mode.
Auto Redial Ring Timer
It specifies the time for which the station that has requested Auto Redial should ring when Auto Redial Call is
placed.
To configure,
• Enter SE mode.
•Dial 3033-Seconds
Where,
Default: 045 seconds.
Valid Range: 000 to 255 seconds.
• Exit SE mode.
Auto Redial Retry Interval
It specifies the time between two Auto Redial attempts.
To configure,
• Enter SE mode.