Matrix Visionpro

105 Matrix VISIONPRO System Manual
•Dial 3029-Seconds
Where,
Default: 015 seconds.
Valid Range: 000 to 255 seconds.
• Exit SE mode.
Auto Redial Retry Count
It specifies the number of times VISIONPRO tries the same number.
To configure,
• Enter SE mode.
•Dial 3030-Count
Where,
Default: 005
Valid Range: 000 to 255.
• Exit SE mode.
Auto Redial Number Count
It specifies the number of external numbers that can be set for Auto Redial simultaneously from one station. Auto
Redial Number Count is 3 and it is non-programmable.
How to use
To set Auto Redial,
• When the external number you are trying is busy, go ON-Hook on Busy Tone.
• Lift the handset.
•Dial 77
• You get Confirmation Tone.
• Replace handset.
In case of multiple Auto Redials, repeat all of the above steps to set Auto Redial for other numbers
(maximum 3 numbers possible).
Example:
Dialed number 0265-2630555 is busy. To use Auto Redial feature, disconnect and dial 77.
To cancel Auto Redial,
• Lift the handset.
•Dial 70.
• You get Confirmation Tone.
• Replace handset.