Matrix Visionpro System Manual

143 Matrix VISIONPRO System Manual
Now, these groups can be allocated to the users depending upon the hierarchy of the user in the organization. A
user can be assigned different CoS groups for Day time and Night time. Once these groups are assigned to the
users, the user’s CoS table would appear as shown below:
• Maximum eight CoS groups can be formed (0-7).
• Each feature can be enabled or disabled in each group.
• The second group is the default CoS group.
How to configure
1. Decide the required number of CoS groups.
2. Prepare the list of features required in each CoS group and configure it using command 4602.
3. To restore default configuration in a CoS group, use the command 4601 (if required).
4. Assign CoS group to a station during Day time using command 4610.
5. Assign CoS group to a station during Night time using command 4611.
On a piece of paper, chalk out the number of CoS groups to be formed and which features are to be assigned to
each group. Then configure as per above instructions,
• Enter SE mode.
• To enable/disable a feature in a CoS group, dial,
4602-1-CoS Group-Feature Index-Code
Where,
CoS Group is from 0 to 7.
Feature Index is from 00 to 30. Feature Indexes from 17 to 19 are left blank. You will get Error Tone if you
try to configure these indexes.
• To enable/disable a feature in all the CoS groups, dial,
4602-*-Feature Index-Code
• To restore default configuration in a CoS group, dial,
4601-1-CoS Group-#
Station Number CoS Group for Day Time CoS Group for Night Time
00 7 1
01 6 4
02 4 4
03 3 3
04 6 4
:: :
:: :
Code Meaning
0 Feature Disabled
1 Feature Enabled

Matrix Visionpro Specifications

General

Brand	Matrix
Model	Visionpro
Category	PBX
Language	English