197 Matrix VISIONPRO System Manual
5. If the requirement cannot be satisfied by default allowed and denied lists, then list down the customized
numbers to be programmed in the allowed and denied lists on a piece of paper.
6. Program the numbers/number strings to be allowed in the allowed list using command 1202 while those to
be denied in the denied list using command 1204 respectively. Refer “Allowed and Denied Lists” to
configure the lists.
7. Assign customized allowed list to the stations using commands 4501 and 4502 for Day and Night time
respectively.
8. Assign customized denied lists to these stations using commands 4511 and 4512 for Day and Night time
respectively.
9. Also assign a default/customized allowed list to these stations for the locked condition using commands
4521.
10. Similarly, assign a default/customized denied list to these stations for the locked condition using
commands 4522.
11. Keep the configuration pages/sheets at a safe place for future reference.
To configure as per the above instructions,
• Enter SE mode.
• If the default allowed lists satisfy the requirement, then assign allowed lists to the stations for Day and
Night time respectively as follows.
• To assign allowed list to a station during Day time, dial,
4501-1-Station-Allowed List
Where,
Station is the software port number of the user from 00 to 07.
Allowed List is from 0 to 7.
• To assign the same allowed list to all stations during Day time, dial,
4501-*-Allowed List
• To assign allowed list to a station during Night time, dial,
4502-1-Station-Allowed List
Where,
Station is the software port number of the user from 00 to 07.
Allowed List is from 0 to 7.
• To assign the same allowed list to all stations during Night time, dial,
4502-*-Allowed List
• If default denied lists satisfy the requirement, then assign denied lists to the stations for Day and Night time
respectively as follows.
• To assign denied list to a station during Day time, dial,
4511-1-Station-Denied List
Where,
Station is the software port number of the user from 00 to 07.
To Next Page
Loading...
Need help?
General
