Matrix Visionpro System Manual

Matrix VISIONPRO System Manual 204
On issuing this command VM configuration will be as follows,
• VM duration will be set to 256 seconds.
• Number of VM parts will be 16.
• Recording source will be set as Telephone.
• Assignment of Voice Message Application to Part Number will be as per the table displayed above.
• Exit SE mode.
Recording/Verifying a Voice Message
To record a message do the following:
Make sure:
• you select a good quality telephone.
• the person recording the message has a clear voice.
• you switch off the fans and there is silence in the room.
• Lift handset.
• Enter in the programming mode from this station.
•Dial 1405-Part Number or 1411 (to record customized MoH).
• You will get the Confirmation Tone.
• Start recording your message.
• The system records whatever is spoken.
• Replace the handset as soon as the message is over (or, wait for the Confirmation Tone). You may also
press the hook switch to avoid delay.
• You will get ring because you are in the programming mode.
• To verify the recorded message, dial 1406-Part Number or 1412 (to playback the customized MoH).
• Listen to the message.
• Repeat the above procedure if you are not satisfied with the message.
On executing the command, 1403-Index, with a different value other than your current Index, all previous
recordings in the system will be deleted.

Matrix Visionpro Specifications

General

Brand	Matrix
Model	Visionpro
Category	PBX
Language	English