35 Matrix VISIONPRO System Manual
Example:
Program the Hunt Timer as 20 seconds.
Solution. Dial 212-20
Hunting Scheme
• To configure the Day and Night Hunting scheme for a trunk, dial,
46-Trunk-Day Hunting Scheme-Night Hunting Scheme
• To configure the Day and Night Hunting scheme for all trunks at once, dial,
46-*-Day Hunting Scheme-Night Hunting Scheme
Where,
Trunk is from 0 to 2.
Hunting Scheme is from 0 to 3. Select the scheme as per the table below.
Different hunting schemes are explained below,
• Hunting Off: In this case, the call lands on the programmed station and only that station would ring.
• Round Robin: In this case, the call lands on the programmed station and rings there till the Hunt Timer
expires; if not answered, then it goes to the next programmed station and again rings there till the Hunt
Timer expires and goes on in this manner.
• Delayed Simultaneous: In this case, the call lands on the programmed station and it rings till the Hunt
Timer expires. Thereafter, all the stations start ringing simultaneously. The call can be answered from any
of the ringing stations.
• Immediate Simultaneous: In this case, the call lands on the programmed stations and all the stations
start ringing simultaneously. Any station can answer the call.
Example:
Program the system so that the call on Trunk1 lands in round robin fashion on programmed stations during Day
time and lands simultaneously on these stations during Night time.
Solution. Dial, 46-1-1-3
For more details, refer “Station Groups” and “Trunk Landing Groups (TLGs)”.
• To exit the wizard mode, dial “0”. You can exit this mode at any time by dialing this command.
Hunting Scheme
a
a.To select the desired Hunting Scheme, refer the follow-
ing descriptions.
Meaning
0 Hunting Off
1 Round Robin
2 Delayed Simultaneous
3 Immediate Simultaneous
To Next Page
Loading...
Need help?
General
