EasyManuals Logo

Matrix Visionpro System Manual

Matrix Visionpro
253 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
Matrix VISIONPRO System Manual 34
To assign the Trunk Landing Destination for Day Mode for all trunks at once, dial,
47-*-Ext1-Ext2-Ext3-Ext4
Where,
Trunk is from 0 to 2.
Ext1 to Ext4 are the flexible numbers of destination stations. Flexible number can be of 1,2,3 or 4 digits.
Maximum four destinations can be programmed for a single trunk.
For details, refer “Station Groups” and “Trunk Landing Groups (TLGs)”.
Example:
Assign station numbers 21, 22 and 23 as the Trunk Landing Destinations for Trunk1 for Day time.
Solution. Dial 47-1- 21-22-23
Trunk Landing Destination for Night Mode
To assign the Trunk Landing Destination for Night Mode for a trunk, dial,
48-Trunk-Ext1-Ext2-Ext3-Ext4
To assign the Trunk Landing Destination for Night Mode for all trunks at once, dial,
48-*-Ext1-Ext2-Ext3-Ext4
Where,
Trunk is from 0 to 2.
Ext1 to Ext4 are the flexible numbers of destination stations. Flexible number can be of 1,2,3 or 4 digits.
Maximum four destinations can be programmed for a single trunk.
For details, refer “Station Groups” and “Trunk Landing Groups (TLGs)”.
Example:
Assign station numbers 24, 25 as the Trunk Landing Destinations for Trunk1 for Night time.
Solution. Dial, 48-1-24-25
Hunt Timer
To configure the Hunt Timer, dial,
212-Timer
Where,
Timer is from 01-99 seconds.
For details, refer “Station Groups”.
Hunt Timer is defined as the time for which a station rings when a trunk call lands on that station. It is
similar to the 'Ring Timer'. On expiry of the Hunt Timer, the next station of the Station Group assigned
to the trunk will start ringing.
For example, maximum four stations can be programmed for a single trunk. Now if the CO office gives
ring for 90 seconds and the Hunt Timer programmed is 18 seconds; then all four stations will ring for 18
seconds each alternately. Refer “Hunting Scheme” below for more details. Default Hunt Timer is 18
seconds.

Table of Contents

Other manuals for Matrix Visionpro

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Matrix Visionpro and is the answer not in the manual?

Matrix Visionpro Specifications

General IconGeneral
BrandMatrix
ModelVisionpro
CategoryPBX
LanguageEnglish

Related product manuals