33 Matrix VISIONPRO System Manual
Example:
Enable Trunk2 and configure Dial type as 'Pulse'.
Solution. Dial 41-2-1-0
DID
• To configure a trunk for DID calls, dial,
43-Trunk-Day Code-Night Code
Where,
Trunk is from 0 to 2
Day Code/Night Code flags are,
For details, refer “Direct Inward Dialing (DID)”.
Example:
Program Trunk2 so that DID facility is disabled in Day time while it is enabled in Night time.
Solution. Dial 43-2-0-1
DOSA
• To configure a trunk for DOSA calls, dial,
45-Trunk-Day Code-Night Code
Where,
Trunk is from 0 to 2.
Day Code/Night Code flags are,
For details, refer “Direct Outward System Access (DOSA)”.
Example:
Program Trunk2 for not allowing DOSA facility in Day time and allowing only during Night time.
Solution. Dial 45-2-0-1
Trunk Landing Destination for Day Mode
• To assign the Trunk Landing Destination for Day Mode for a trunk, dial,
47-Trunk-Ext1-Ext2-Ext3-Ext4
Code Meaning
0 Disable
1 Enable
Code Meaning
0 Disable
1 Enable
To Next Page
Loading...
