Matrix VISIONPRO System Manual 64
By default, code 0 is selected.
• To configure the same CO Line Type for all trunks, dial,
3113-*-Code
• To configure the Answer Supervision type for a trunk, dial,
3114-1-Trunk-Code
Where,
Trunk is the software port number from 0 to 2.
Default code value is 0.
• To configure the same Answer Supervision type for all trunks, dial,
3114-*-Code
• To configure the Pseudo Answer Supervision Timer for a trunk, dial,
3117-1-Trunk-Seconds
Where,
Trunk is the software port number from 0 to 2.
Seconds is from 1 to 255 seconds.
Default is 10 seconds.
• To configure the same Pseudo Answer Supervision Timer for all trunks, dial,
3117-*-Seconds
• To configure the Disconnect Supervision type for a trunk, dial,
3115-1-Trunk-Code
Where,
Trunk is the software port number from 0 to 2.
Default code value is 0.
• To configure the same Disconnect Supervision type for all trunks, dial,
3115-*-Code
• To configure the Open Loop Disconnect Timer for a trunk, dial,
3116-1-Trunk-Code
Where,
Code Answer Supervision Type
0 Pseudo Answer
1 Polarity Reversal
Code
Disconnect Supervision Type
0None
1 Polarity Reversal
2 Open Loop Disconnect