71 Matrix VISIONPRO System Manual
Trunk is the software port number from 0 to 2.
Default code is 1.
• To configure the same Current Limiting Mode for all trunks, dial,
3128-*-Flag
• To configure the Minimum Loop Current for a trunk, dial,
3129-1-Trunk-Code
Where,
Trunk is the software port number from 0 to 2.
Default code is 0.
• To configure the same Minimum Loop Current for all trunks, dial,
3129-*-Code
• To configure the TIP-RING Voltage for a trunk, dial,
3130-1-Trunk-Code
Where,
Trunk is the software port number from 0 to 2.
Default code is 3.
• To configure the same TIP-RING Voltage for all trunks, dial,
3130-*-Code
• To configure the Ringer Impedance for a trunk, dial,
3131-1-Trunk-Code
Where,
Flag
Meaning
0 Current limiting mode disabled
1 Current limiting mode enabled
Code
Minimum Loop
Current (in mA)
010
112
214
316
Code
TIP-RING Voltage
(in Volts)
03.1
13.2
23.35
33.5
To Next Page
Loading...
