Maxcess MAGPOWR CYGNUS-S3 Series - Splice Features (Optional)

OPTIONAL FUNCTIONS
www.maxcessintl.com
CYGNUS
MI 850A316 1 B
Page 31 of 66
8.8 Splice features (optional)
(NOT APPLICABLE FOR READOUT ONLY OPERATION)
The CYGNUS contains helpful splice tools that control output during a splice and can reduce the tension transients
typically experienced during a splice.
Typically input the
inverse of the build
ratio.
Selecting “yes” will take If the new roll feature is used, each time
the last running output and the tension is turned off this screen will
multiply by the splice appear.
multiplier value
Select YES if
you are
starting a
new roll
The operator will
be prompted to
enter the new roll
diameter
dia.core
dia.rollfullMax.
Use Unwind For 
rollfull
dia.core
Use Rewind For 