McHale Orbital - Machine setup 2

McHale Orbital Round Bale Wrapper
47
7.4.3 Machine setup 2
Use the following buttons to navigate the Machine setup 2:
 Toggle key to move the arrow head to each of the parameters
 + and - keys to change the value of the selected parameter
 ESC to return to the Machine Menu
Float Position Sets the float position of the load arm. Adjustable
between 1 (low) and 5 (high). Set to ‘X’ to disable.
Load Arm Speed
This controls the speed of the load arm. Set to a low
value for gentle loading of the bale. Set to higher value
for faster loading of the bale. The value is adjustable
from 1 (low) to 10 (high). 5 is the default value.
Bale Rotate Time Time to rotate the bale on the rollers at the end of auto
load cycle. Set to 0.0s to disable.
Wrapped Bale Rotate Time Time to rotate the wrapped bale on the rollers at the
end of the wrapping. This is useful for pressing the
plastic tails into the bale. Set to 0.0s to disable.
Tip Pause Time This is used to adjust the tip arm pause time in the
down position during a tip cycle.